We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
Flexible mounting tether for C-face motor mount, 3.4" to 5.9" bolt circle, flattened
Flattened flexible mounting bracket made from stainless steel that flexes to accommodate the axial misalignment between the rigidly coupled encoder/motor shafts and the motor mount.
Designed to tether the encoder and prevent it from rotating without rigidly attaching it to the motor frame. Ideally the tether is held in position by placing a pin parallel to the motor shaft through the tether's slot and fastening the pin to the motor frame. The pin prevents the encoder from rotating, and allows it to float on the motor shaft.
The MB-FB2A is made of .015" (.38mm) thick stainless steel that flexes to accommodate the axial misalignment between the rigidly coupled encoder/motor shafts and the motor mount. Failure to use a flexible mounting such as this can significantly reduce the life of the encoder's bearings.
Compatible with:
- Shaft Encoders: R20, R20-P, RG, RJ, RL and RL-P
- Hollow Shaft Encoders: HS20 and HS20-P
Part Number: MB-FB2A
Catalog Number: 32900
DOWNLOAD 3D
STEP MB-FB2A
